Yamanashi Industrial Technology Center

Ōtsu-shi, Japan

Yamanashi Industrial Technology Center

Ōtsu-shi, Japan

Time filter

Source Type

Mochizuki T.,Yamanashi Industrial Technology Center | Mochizuki T.,Yamanashi University | Omi T.,Yamanashi University | Takigami Y.,Yamanashi University | And 2 more authors.
Kobunshi Ronbunshu | Year: 2016

Flexible transparent electrodes were fabricated by line patterning of conductive inks consisting of poly(3,4-ethylenedioxythiophene) doped with poly(4-styrenesulfonate) (PEDOT/PSS) and ethylene glycol on PET films. The average values of thickness, sheet resistance (Rs), electrical conductivity, total light transmittance (TT), and haze of the flexible transparent electrodes in the range of PEDOT/PSS dispersion between 80395 wt% were found to be 101 nm, 160Ω/□, 630 S/cm, 95.5% and 1.3%, respectively. The standard deviations of in-plane distributions of Rs (av. 146Ω/□) and TT (av. 93.5%) were 3.9Ω/□ and 0.2%, respectively, indicating high uniformity with excellent electrical and optical properties as flexible transparent electrodes. Furthermore, a polymer dispersed liquid crystal (PDLC) display was fabricated using the flexible PEDOT/PSS transparent electrodes. It was found that the PDLC display successfully operated by the opaque/transparent change due to the scattering/non-scattering transition caused by the electric field applied through top and bottom PEDOT/PSS electrodes. ©2016, The Society of Polymer Science, Japan.


Matsumoto T.,Yamanashi University | Mizuguchi K.,Yamanashi University | Horii T.,Yamanashi University | Sano S.,Yamanashi University | And 11 more authors.
Japanese Journal of Applied Physics | Year: 2011

Transparent conducting ZnO films are deposited by plasma-assisted deposition on glass and plastic substrates at temperatures as low as 50 °C. The effects of Ga doping and growth temperature on electrical properties are studied using Hall measurement and X-ray diffraction. Carrier density increases with Ga doping for both 50 and 300 °C growth. For low-temperature growth, the carrier mobility in undoped ZnO films is the same as that in high-temperature-grown films, but it becomes lower as the Ga doping level becomes higher. Lattice expansion in both c and a axes directions is observed for low-temperature-grown highly Ga-doped films. The relation between the mobility reduction and the lattice expansion is discussed. © 2011 The Japan Society of Applied Physics.


Zaaba S.K.,Yamanashi University | Zaaba S.K.,University Malaysia Perlis | Akitsu T.,Yamanashi University | Ohkawa H.,Yamanashi University | And 4 more authors.
IEEJ Transactions on Fundamentals and Materials | Year: 2010

The purpose of this paper is to present and compare disinfection effect of plasma by means of Atmospheric Pressure Glow plasma and streamer discharge. Geobacillus stearothermophilus was used as biological indicator for disinfection process. The effect of blades after irradiated in plasma was also studied by SEM analysis. It was found that the disinfection process was effective when the cylindrical configuration was applied. Carbon steel blade was also found to be deteriorated after immersed in plasma irradiation. Results indicate that disinfection can be achieved and at the same time deteriorations of the tools were observed. © 2010 The Institute of Electrical Engineers of Japan.


Muranaka T.,Yamanashi University | Sakano T.,Yamanashi University | Mizuguchi K.,Yamanashi University | Nabetani Y.,Yamanashi University | And 6 more authors.
Physica Status Solidi (C) Current Topics in Solid State Physics | Year: 2010

Structural evaluation of the ZnO epitaxial layers grown by plasma-assisted molecular beam epitaxy (PAMBE) on the GaAs (111)B, c-plane (0001) and a-plane (11-20) sapphire (α-Al2O3) substrates was demonstrated by using high-resolution X-ray diffraction (XRD). The in-plane epitaxial relationships between the ZnO layers and the substrates were found to be ZnO(0001)〈11-20〉II GaAs(111)〈1-10〉, ZnO(0001)〈11- 20〉IIα-Al2O3 (0001) 〈1-100〉 and ZnO (0001)〈11-20〉IIα-Al2O3(11-20) 〈0001〉. All the ZnO layers were highly oriented to the c-axis but larger fluctuations of the c-axis were observed for the layers on the GaAs(111)B substrates. The lattice parameters of the ZnO layers were evaluated from the θ-2θ and ω-2θ scans, and reciprocal lattice mappings (RLMs). The in-plane compressive strains up to 0.3% in the ZnO layers on both the c-plane and a-plane sapphire substrates, and the in-plane tensile strains up to 0.4% in the ZnO films on the GaAs(111)B substrates were observed. © 2010 Wiley-VCH Verlag GmbH & Co. KGaA.


Suzuki D.,Yamanashi Industrial Technology Center | Yatsushiro K.,Yamanashi Industrial Technology Center | Sano M.,Yamanashi Industrial Technology Center | Ishiguro T.,Yamanashi Industrial Technology Center | And 2 more authors.
Zairyo/Journal of the Society of Materials Science, Japan | Year: 2015

Plastic forming for magnesium alloy requires warm working. However, warm working causes micro-structure change or strength decreasing to mechanical characteristics grant material by work hardened, or grain refinement. To study warm working conditions, it is important to find out β phase (β-Mg17Al12) transition of magnesium alloy and crystal grain growth in heating process. In this report, rolled AZ61 magnesium alloy crystalline structure changing in heating process were in-situ measured by synchrotron radiation. As results, crystal grain growth of α-magnesium, and β-Mg17Al12 solution was not found under holding temperature 400°C till 50 seconds. Furthermore, temperature rising rate 2°C /sec or over is necessary at time. © 2015 The Society of Materials Science, Japan.


Hoshino K.,University of Tsukuba | Nakagomi H.,Yamanashi Industrial Technology Center
2014 36th Annual International Conference of the IEEE Engineering in Medicine and Biology Society, EMBC 2014 | Year: 2014

This study focuses on a technique for measuring the angle of rotational eye movement by tracking the conjunctival blood vessel ends of sclera, instead of grayscale iris patterns used in the existing techniques. It is because the blood vessel images of sclera have high grayscale contrasts. This technique especially recognizes the contour of the iris to detect the target conjunctival blood vessel end and use the degree of similarity by means of template matching to select automatically the blood vessel end to be tracked. The search region is limited by template matching to achieve low processing cost and high accuracy and resolution even when the background light varies. © 2014 IEEE.


Kasai S.,Yamanashi Industrial Technology Center | Tanzawa T.,Yamanashi Industrial Technology Center | Kiyohiro N.,Yamanashi Industrial Technology Center
Nihon Kikai Gakkai Ronbunshu, C Hen/Transactions of the Japan Society of Mechanical Engineers, Part C | Year: 2011

Recently, with rapid progress of the computer hardware and 3D-CG software technologies, the 3D design system such as CAD and CAE, is popularized in manufactures. However, 3-dimensional data is produced now using man-machine interfaces, for example a 2-dimensional mouse and a keyboard, and using intricacy combined operations of those devices. So, designers said, It is far from sensate creation. Spark of imagination doesn't get interested. Therefore, little artistic designers especially jewel designers create using the 3D design system. In this paper, we describe the Virtual-glove using ERF (Electro Rheological Fluid) to feel the 3D virtual objects on operator's hand, propose the new actuator device for the small and lightweight virtual glove. Then we show the characteristics of ERF to reaction force. The results is shown the principle of reaction force using the device was clarified. © 2011 The Japan Society of Mechanical Engineers.


Ogata-Saito M.,Yamanashi Industrial Technology Center | Kimura H.,Yamanashi Industrial Technology Center | Iimura Y.,Yamanashi Industrial Technology Center
Nippon Shokuhin Kagaku Kogaku Kaishi | Year: 2014

Reuse of the rice bran byproduct of sake brewing was proposed. Koji was prepared using red rice bran. Seed koji was added to steamed red rice bran at a rate of 0.5%, and incubated at 30°C and 90% humidity for 1-3 days. Next, we obtained a red rice bran koji that exhibited high saccharification ability. The starch in white rice bran was effectively saccharified by the red rice bran koji. When preliminary saccharification for 90 minutes was carried out to secure fluidity of the culture medium, simultaneous saccharification and lactic acid fermentation using Lactobacillus rhamnosus was possible. Consequently, a lactic acid concentration > 12 g/100ml (99.3% L-lactic acid) was obtained after 72-hour cultivation. Copyright © 2014, Japanese Society for Food Science and Technology.


Saito M.,Yamanashi Industrial Technology Center | Onda T.,Yamanashi Industrial Technology Center | Kojima M.,Yamanashi Industrial Technology Center | Naganuma K.,Yamanashi Industrial Technology Center | And 2 more authors.
Nippon Shokuhin Kagaku Kogaku Kaishi | Year: 2010

To extract the major allergen (Pru p3) from peach skin, a small-scale method was developed. This method involves shaking a small amount of peach skin on a high speed shaker instead of homogenizing it. Protein was extracted in sufficient quantity by shaking 5 g of skin from one peach in a buffer solution (pH 5) containing 20 mmol/L ascorbic acid sodium salt. Total RNA was extracted from mature peach skin by the SDS-phenol method to obtain high concentration mRNA. Following purification of total RNA using a commercial kit, cDNA was amplified by RT-PCR using mRNA and oligo dT primers. Pru p3 expression in peach was confirmed by nested PCR using cDNA templates.

Loading Yamanashi Industrial Technology Center collaborators
Loading Yamanashi Industrial Technology Center collaborators