Time filter

Source Type

Bannikov A.I.,Volgograd State Technical University | Makarova O.A.,Volgograd State Technical University | Borodkina A.M.,Volgograd State Technical University | Lyaskovskii A.A.,OAO Volzhskii Trubnyi Zavod
Russian Engineering Research | Year: 2015

The surface wear of the plate the cone-plate frictional pair in an expansion system is investigated. © 2015, Allerton Press, Inc.


Bannikov A.I.,Volgograd State Technical University | Dyatlov N.A.,Volgograd State Technical University | Antonov A.S.,OAO Volzhskii Trubnyi Zavod | Makarova O.A.,Volgograd State Technical University
Russian Engineering Research | Year: 2015

Impact cutting of hot-rolled metal by disk saws is analyzed by high-speed video recording. © 2015, Allerton Press, Inc.


Bannikov A.I.,Volgograd State Technical University | Dyatlov N.A.,Volgograd State Technical University | Permyakov I.L.,Volgograd State Technical University | Antonov A.S.,OAO Volzhskii Trubnyi Zavod
Russian Engineering Research | Year: 2014

The chip formation in the cutting of hot-rolled products is considered, in research at OAO Volzhskii Trubnyi Zavod. © 2014, Allerton Press, Inc.


Vydrin A.V.,OAO RosnNITI | Kuznetsov V.I.,OAO RosnNITI | Ananyan V.V.,OAO Volzhskii Trubnyi Zavod
Steel in Translation | Year: 2010

The flow of viscous liquid (used to simulate lubricant) as it is compressed with shear by parallel plates (surfaces) may be determined by the method here proposed. This method provides information regarding the flow kinematics and the contact forces. Practical application of the results permits estimation of the surface quality of the metal when hot-rolled pipe passes through rolling mills of various types. © 2010 Allerton Press, Inc.


Korsakov A.A.,OAO RosNITI | Zvonarev D.Y.,OAO RosNITI | Korol' A.V.,OAO RosNITI | Ul'yanov A.G.,OAO Volzhskii Trubnyi Zavod | Niklyaev A.V.,OAO Volzhskii Trubnyi Zavod
Steel in Translation | Year: 2011

A method is proposed for determining the basic setup parameters in piercing on a cross-helical rolling mill with barrel-shaped rollers. This method takes account of the roller rotation in terms of the supply angle and the roller grooving (the presence of one or two cones in the roller's input section and the position of the roller's axis of rotation in terms of the supply angle relative to the roller gorge). © 2011 Allerton Press, Inc.


Stolyarov V.I.,OAO RosNITI | Pyshmintsev I.Y.,OAO RosNITI | Struin I.O.,OAO RosNITI | Permyakov I.L.,OAO Volzhskii Trubnyi Zavod
Steel in Translation | Year: 2010

Full-scale hydraulic and pneumatic tests of spiral- and straight-seam gas pipe (diameter 1420 mm) produced by OAO Volzhskii Trubnyi Zavod are described. Satisfactory and equivalent resistance of different types of pipe to ductile failure is established. In terms of its operational characteristics, the pipe may be used in pipelines of working pressure up to 11.8 MPa in any Russian climatic zones, including the Far North. © 2010 Allerton Press, Inc.

Loading OAO Volzhskii Trubnyi Zavod collaborators
Loading OAO Volzhskii Trubnyi Zavod collaborators