Entity

Time filter

Source Type


Arkadov G.V.,RAS Institute for Nuclear Research | Zhukavin A.P.,General Energy Technologies | Kroshilin A.E.,RAS Institute for Nuclear Research | Parshikov I.A.,RAS Institute for Nuclear Research | And 2 more authors.
Thermal Engineering (English translation of Teploenergetika) | Year: 2014

The article describes the “Virtual Digital VVER-Based Nuclear Power Plant” computerized system comprising a totality of verified initial data (sets of input data for a model intended for describing the behavior of nuclear power plant (NPP) systems in design and emergency modes of their operation) and a unified system of new-generation computation codes intended for carrying out coordinated computation of the variety of physical processes in the reactor core and NPP equipment. Experiments with the demonstration version of the “Virtual Digital VVER-Based NPP” computerized system has shown that it is in principle possible to set up a unified system of computation codes in a common software environment for carrying out interconnected calculations of various physical phenomena at NPPs constructed according to the standard AES-2006 project. With the full-scale version of the “Virtual Digital VVER-Based NPP” computerized system put in operation, the concerned engineering, design, construction, and operating organizations will have access to all necessary information relating to the NPP power unit project throughout its entire lifecycle. The domestically developed commercial-grade software product set to operate as an independently operating application to the project will bring about additional competitive advantages in the modern market of nuclear power technologies. © Pleiades Publishing, Inc., 2014.


Kroshilin A.E.,General Energy Technologies | Kroshilin V.E.,Moscow State University
Thermal Engineering (English translation of Teploenergetika) | Year: 2016

Different models used in calculating flows of a two-phase coolant are analyzed. A system of differential equations describing the flow is presented; the hyperbolicity and stability of stationary solutions of the system is studied. The correctness of the Cauchy problem is considered. The models’ ability to describe the following flows is analyzed: stable bubble and gas-droplet flows; stable flow with a level such that the bubble and gas-droplet flows are observed under and above it, respectively; and propagation of a perturbation of the phase concentration for the bubble and gas-droplet media. The solution of the problem about the breakdown of an arbitrary discontinuity has been constructed. Characteristic times of the development of an instability at different parameters of the flow are presented. Conditions at which the instability does not make it possible to perform the calculation are determined. The Riemann invariants for the nonlinear problem under consideration have been constructed. Numerical calculations have been performed for different conditions. The influence of viscosity on the structure of the discontinuity front is studied. Advantages of divergent equations are demonstrated. It is proven that a model used in almost all known investigating thermohydraulic programs, both in Russia and abroad, has significant disadvantages; in particular, it can lead to unstable solutions, which makes it necessary to introduce smoothing mechanisms and a very small step for describing regimes with a level. This does not allow one to use efficient numerical schemes for calculating the flow of two-phase currents. A possible model free from the abovementioned disadvantages is proposed. © 2016, Pleiades Publishing, Inc.


Osadchaya D.Yu.,General Energy Technologies | Fuks R.L.,General Energy Technologies
Thermal Engineering (English translation of Teploenergetika) | Year: 2014

The architecture of the SAM software package intended for modeling beyond-design-basis accidents at nuclear power plants equipped with VVER reactors evolving into a severe stage with core melting and failure of the reactor pressure vessel is presented. By using the SAM software package it is possible to perform comprehensive modeling of the entire emergency process from the failure initiating event to the stage of severe accident involving meltdown of nuclear fuel, failure of the reactor pressure vessel, and escape of corium onto the concrete basement or into the corium catcher with retention of molten products in it. © 2014 Pleiades Publishing, Inc.

Discover hidden collaborations