Entity

Time filter

Source Type


Sanaev N.K.,Dagestan State Technical University
Russian Engineering Research | Year: 2014

The performance of bushes in the 4Ch8.5/11 diesel engine is optimized on the basis of mathematical experiment design. Their wear resistance may be improved by finishing on the basis of special roller burnishing, rather than honing. © 2014, Allerton Press, Inc. Source


Gasanov V.M.,Dagestan State Technical University
Journal of Engineering Physics and Thermophysics | Year: 2011

The surface diameters of gas bubbles at the liquid-gas interface whose burst leads to the formation of aerosol from a thin surface microlayer of thickness 1 μm and less have been determined experimentally. Precisely the anomalous concentrations of such a microlayer are responsible for the fractionation of substances in the process of ocean-atmosphere exchange. ©2011 Springer Science+Business Media, Inc. Source


Kallaev S.N.,Russian Academy of Sciences | Omarov Z.M.,Russian Academy of Sciences | Mitarov R.G.,Dagestan State Technical University | Bilalov A.R.,Russian Academy of Sciences | And 2 more authors.
Journal of Experimental and Theoretical Physics | Year: 2010

The heat capacity, thermal expansion coefficient, and deformation of the PLZT-9/65/35 compound are studied in the temperature range 150-800 K. Diffuse anomalies are detected in the temperature dependences of the heat capacity and thermal expansion coefficient over wide temperature ranges of 250-650 and 330-550 K, respectively. The anomalous behavior of the heat capacity in the temperature range 250-650 K is shown to be caused by the appearance of two-level states (Schottky anomaly). The results obtained are discussed along with the data of structural and dielectric studies. © 2010 Pleiades Publishing, Ltd. Source


Sanaev N.K.,Dagestan State Technical University | Guseinov M.R.,Dagestan State Technical University
Russian Engineering Research | Year: 2010

Systemic analysis of frictional-component designs for diesel engines is considered. The concept of an elementary frictional cell may be used in evaluating the efficiency of such designs. © 2010 Allerton Press, Inc. Source


Guseinov R.V.,Dagestan State Technical University | Rustamova M.R.,Dagestan State Technical University
Russian Engineering Research | Year: 2013

Helical bits are generally used for machining holes. Means of improving their design are developed. Recommendations are made for more rapid machining of small-diameter holes. © 2013 Allerton Press, Inc. Source

Discover hidden collaborations